Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 466)

466 K2 Storage System Instruction Manual September 7, 2007
Chapter 10 Installing the Level 20R Storage System
4. In the Controller Slot Number field enter 0 and then press Enter . The settings from
controller 0 are loaded into the Controller Network Settings dialog box and are
available for you to modify.
5. Enter the control network IP address and other network settings.
6. You want SNMP trap messages go to the NetCentral server PC, so for SNMP
Configuration enter the IP address of the NetCentral server PC. You can also enter
IP addresses for other SNMP managers to which you want to send SNMP trap
messages.
7. For the RAID chassis with two controllers, in the Controller Slot Number field
enter 1 and then press Enter . The settings from controller 1 are loaded into the
Controller Network Settings dialog box and are available for you to modify. Repeat
the previous steps to configure controller 1.
8. Click OK to save settings and close.
9. In Storage Utility click View | Refresh . Continue with the next procedure “Binding
disk modules” .
Binding disk modules
Use the following procedure to bind disk modules as required for the Level 20R
storage system.
Also refer to “About RANKs and LUNs in Storage Utility” in Chapter 15, Overview
of K2 Storage Tools.
NOTE: Binding destroys all user data on the disks.
1. In the Storage Utility main window, identify bound RANKs and unbound disks by
their placement in the hierarchy of the tree view. In the following illustration, disk
numbers are represented by “XX”. Refer to
“Identifying disks” on page 744 for an
explanation of how disks are actually numbered in Storage Utility.