beautypg.com

Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 User Manual

Page 756

background image

756

K2 Storage System Instruction Manual

September 7, 2007

Chapter 18 Administering and maintaining the K2 Storage System

If you decide you need to change the RAID topology and alter the cabling of existing
Expansion chassis, you must unbind all existing RAID disks before shutting down the
system. Failure to do so results in a configuration mismatch and controller faults.

NOTE: Refer to the Instruction Manual for your RAID storage chassis for
procedures on removing and replacing the RAID controller module.

To upgrade controllers, do the following:

1. Power down the entire K2 Storage System, including all RAID devices.

2. Remove cabling to controllers.

3. Remove the Level 10/20 controller or controllers.

4. Insert the Level 30 controller or controllers.

5. Re-cable controller or controllers. If you do not plan to rebind RAID disks, you

must connect existing Expansion chassis just as they were before.

6. Connect added Expansion chassis, if any.

7. Power up the K2 Storage System.

8. Download RAID controller microcode, as instructed in

“Loading RAID controller

microcode” on page 751

. Refer to K2 Storage System Release Notes for microcode

version.

9. Proceed as follows:

• If you did not add Expansion chassis or otherwise change the topology, the

upgrade procedure is complete.

• If you added or re-cabled Expansion chassis, depending on the changes you are

making, do one or more of the following:

- Bind disks

- Make a new file system

- Expand the file system

Configuring Level 2 RAID chassis network and SNMP settings

Through Storage Utility you can configure the following settings on a RAID chassis:

• IP address

• Subnet mask

• Gateway Address

• SNMP trap destinations

For the Level 2 RAID chassis, network and SNMP settings are set and stored on the
LAN card. Therefore, if the RAID chassis has two RAID controllers, they are
configured as a single device, as in the following procedure.

1. In the Storage Utility, right-click the icon for a RAID controller and select

Configuration | Network Properties

. The Network Settings dialog box opens.