Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 593)

September 7, 2007 K2 Storage System Instruction Manual 593
Level 30R system power-on procedure
Level 30R system power-on procedure
Power on Level
Level 30R (iSCSI)
K2 Storage System
Power on and verify
control point PC .
Refer to page 596 for procedures.
Power on and verify
HP ProCurve switches .
Refer to page 595 for procedures.
Power on and verify
RAID devices .
Refer to page 595 for procedures.
Elapsed time: 5 minutes Elapsed time: 1 minute
Power on the primary
K2 Media Server. This
is the server that was
primary when you last
powered down the K2
Storage System.
From the control
point PC, in the K2
System
Configuration
application, open
Server Control
Panel .
Put the K2 Media Server into service:
In Server Control Panel, click
Start to
start Failover Monitor.
No
In Server Control Panel,
check the Failover Monitor
indicator.
Yes
No
Yes
Green
indicator?
Elapsed time:
3 minutes
In Server
Control Panel,
check the
media file
system
indicator.
Green
indicator?
Elapsed time:
30 seconds