Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 302)

302 K2 Storage System Instruction Manual September 7, 2007
Chapter 7 Installing the Level 10 Storage System
19.If you have a trunk, verify that for the default VLAN the trunk is displayed in the
Tagged Ports column.
20.If you have two switches, repeat this procedure for the other switch.
21.Close the switch configuration application.
Setting up the L10 K2 Media Server
The Dell PowerEdge 860 is qualified as the platform for the L10 K2 Media Server.
Do the following to prepare the L10 K2 Media Server:
• Install the server in its permanent location. Refer to the rack mount instructions that
you received with the server’s product bundle.
• Provide power to the servers.
• Connect cables as follows:
Dell 860 PowerEdge server
Connect the iSCSI interface port to a media port on the GigE switch. Connect
the motherboard GigE port 1 and GigE port 2 to control ports on the GigE
switch.
Connect the Fibre Channel port to the RAID storage device.
• Assign a control network IP address to GigE port 1. Use standard Windows
procedures. Refer to “Networking tips” .
• Change the hostname. Use standard Windows procedures.
• Configure SNMP properties so the trap destination points to the NetCentral server
PC. Use standard Windows procedures. If you are not using the SNMP community
name “public”, configure the community name and set permissions to RW. Also
make sure that the Authentication trap is enabled.
Also refer to “K2 Media Server descriptions” on page 653 .
1
1
2 2
To medi a (i S C S I)
port on GigE s witch
Fi b re Ch a nnel
to RAID controller
To control port
on GigE
s witch
FTP: To control port
on GigE
s witch