Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 641)

September 7, 2007 K2 Storage System Instruction Manual 641
Configuring the second NH server for NL10R
Software Configuration
This page checks for the
software required to support
the roles you selected on the
previous page.
Software required on a
NL10R K2 Media Server is
as follows:
• K2 Server
• File System Server
• File System Client
• QuickTime
• MPIO
NOTE: MPIO
software is required
on K2 Media
Servers in the
NL10R system and
in other nearline
redundant systems. If software with Yes in the Required column reports as Not Installed, you
must first install it on the K2 Media Server before continuing. Refer to
Chapter 16, Managing K2 software. After installing the software, click
Check Software . When all required software reports as Installed, click
Next .
Network Configuration
This page displays the
control network Ethernet
port, and allows you to
configure the FTP/
Streaming network Ethernet
port.
The top port is the port over which the K2 System Configuration
application is communicating with the K2 Media Server. If correctly
configured, it is already assigned the control network IP address, as
displayed on this page.
Select the other port and click
Modify . A network configuration dialog
box opens. Enter the FTP/Streaming IP address and the subnet mask and
click
Apply .
Click Next .
On this page… Do this…