Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 551)

September 7, 2007 K2 Storage System Instruction Manual 551
Setting up the Level 30R redundant GigE switches
c. For the trunked ports, set Port Enabled to Yes . On some switch models, some
ports are disabled by default, so make sure you enable them. Leave Mode as
default of
Auto .
d. Set Flow Control as follows:
- Set to Enable .
NOTE: This setting is for the 2900 series switch. Other switch models might require
a different setting.
e. Click Apply Settings .
8. On the Port Configuration page, do one of the following:
• If you do not have trunks, select all ports.
• If you have trunks, select the remaining ports (the ports not trunked).
This setting
varies depending
on switch model.
Set as instructed
in text.