Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 271)

September 7, 2007 K2 Storage System Instruction Manual 271
Configuring RAID
3. Continue with the next procedure to use Storage Utility to configure the file
system.
Leave the Configure K2 Server wizard open while you are using Storage Utility.
When you are done with Storage Utility, you continue with the wizard.
Configuring RAID
Use Storage Utility to complete the configuration of the L3 RAID chassis, as
explained in the following topics:
• “Verifying controller microcode”
Network Configuration
This page displays the
control network Ethernet
port, and allows you to
configure the FTP/
Streaming network Ethernet
port.
NOTE: This page
does not configure
the iSCSI interface
(media network)
ports.
The top port is the port over which the K2 System Configuration
application is communicating with the K2 Media Server. If correctly
configured, it is already assigned the control network IP address, as
displayed on this page.
Select the other port and click
Modify . A network configuration dialog
box opens. Enter the FTP/Streaming IP address and the subnet mask and
click
Apply .
Click Next .
File System Server
Configuration
Click Launch Storage Manager . Storage Utility opens.
On this page… Do this…