Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 311)

September 7, 2007 K2 Storage System Instruction Manual 311
Configuring the Level 10 storage system
Configuring the Level 10 storage system
Use the topics in this section to do the initial configuration of the Level 10 storage
system.
• “Prerequisites for initial configuration” on page 311
• “Defining a new K2 Storage System” on page 312
• “Configuring the server - Part 1” on page 314
• “Configuring RAID” on page 316
• “Creating a new file system” on page 321
• “Configuring the server - Part 2” on page 323
Prerequisites for initial configuration
Before beginning your initial configuration, make sure the devices of the K2 Storage
System meet the following prerequisites. Refer to sections earlier in this manual for
detailed information. Also refer to
Chapter 14, “Description of K2 Storage Devices” .
Devices Prerequisite for Level 10 configuration
Control point PC Ethernet cable connected
Control Point software installed
Control network IP address assigned
Network communication over the control network with all other K2
devices
Power on
Ethernet switch Ethernet cables connected
Control network IP address assigned
VLANs set up
Trunks set up
Power on
K2 Media Server Ethernet cables connected
Fibre Channel cable connected
Software installed, as from the factory, including QuickTime 7
Control network IP address assigned
Power on