Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 235)

September 7, 2007 K2 Storage System Instruction Manual 235
Level 3R system power-on procedure
Level 3R power-on procedure page 2
Power on the primary
media file system/
database K2 Media
Server. This is the
server that was
primary when you last
powered down the K2
Storage System.
From the control
point PC, in the K2
System
Configuration
application, open
Server Control
Panel .
Put the K2 Media Server into service:
In Server Control Panel, click
Start to
start Failover Monitor.
No
In Server Control Panel,
check the Failover Monitor
indicator.
Yes
No
Yes
Power on the primary
FTP/bridge K2 Media
Server.
From the control point PC, at
the command prompt, ping
the K2 Media Server.
No
Yes
In Server
Control Panel,
check the
media file
system
indicator.
K2
Media Server
responds to ping?
Elapsed time:
3 minutes
Green
indicator?
Elapsed time:
3 minutes
Green
indicator?
Elapsed time:
30 seconds
Continue with page 3 of Level 3R power-on procedure