Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 716)

716 K2 Storage System Instruction Manual September 7, 2007
Chapter 18 Administering and maintaining the K2 Storage System
Using Storage Utility
When doing configuration or service work on the media file system, the media
database, or the RAID storage devices of an existing K2 Storage System, the primary
tool is the Storage Utility. Refer to
“Storage Utility” on page 663 for a general
description.
CAUTION: Use the Storage Utility only as directed by a documented
procedure or by Grass Valley Support. If used improperly, the Storage
Utility can render your K2 Storage System inoperable or result in the
loss of all your media.
The installation chapters earlier in this document provide instructions for using
Storage Utility as you initially set up and configure a K2 Storage System. You should
refer to those instructions for information that is specific to the level of your K2
Storage System. Procedures in this section are as follows:
• “Accessing Storage Utility” on page 716
• “Overview of Storage Utility” on page 717
Accessing Storage Utility
To access the Storage Utility, you must open it from within the K2 System
Configuration application. Access permissions are passed from the K2 System
Configuration application to the Storage Utility as it opens, so make sure that you are
logged in with sufficient permissions.
You open the Storage Utility from within the K2 System Configuration application in
the following ways:
• In the K2 System Configuration application tree view, select the name of the K2
Storage System, which is the top node of the storage system tree. Then click the
Storage Utility button. Storage Utility opens. In this case the connection to the
RAID storage devices is via the K2 Media Server first configured, which is
designated as server 1, server A, or server 1A, depending on the level of the storage
system.
• In the K2 System Configuration application tree view, open the node for a K2
Media Server and select the File System Server node to open its property page. On
the property page click Launch Storage Utility . Storage Utility opens. In this case
the connection to the RAID storage devices is via the selected K2 Media Server.
NOTE: Do not run Storage Utility on a shared storage K2 Media Client.
NOTE: Do not run Storage Utility as a stand-alone application, separate from the
K2 System Configuration application. To maintain a valid K2 Storage System all
configuration must be controlled and tracked through the K2 System Configuration
application.
!