Configuring raid – Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 User Manual
Page 632

632
K2 Storage System Instruction Manual
September 7, 2007
Chapter 13 Installing the Nearline 10 Storage System
3. Continue with the next procedure to use Storage Utility to configure the file
system.
Leave the Configure K2 Server wizard open while you are using Storage Utility.
When you are done with Storage Utility, you continue with the wizard.
Configuring RAID
Use Storage Utility to complete the configuration of the Nearline 10 RAID chassis, as
explained in the following topics:
Network Configuration
This page displays the
control network Ethernet
port, and allows you to
configure the FTP/
Streaming network Ethernet
port.
The top port is the port over which the K2 System Configuration
application is communicating with the. If correctly configured, it is
already assigned the control network IP address, as displayed on this
page.
Select the other port and click
Modify
. A network configuration dialog
box opens. Enter the FTP/Streaming IP address and the subnet mask and
click
Apply
.
Click
Next
.
File System Server
Configuration
Click
Launch Storage Manager
. Storage Utility opens.
On this page…
Do this…