Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 679)

September 7, 2007 K2 Storage System Instruction Manual 679
Restoring from the generic recovery disk image on E:
Upon restart, a Found New Hardware wizard and/or messages about services/
drivers can be displayed.
25. To respond to Found New Hardware wizards and/or messages about services/
drivers, refer to K2 Storage System Release Notes for instructions. The way you
respond depends on the type of K2 Media Server and the recovery disk image
version you are using.
26. Set the Rx/Tx Descriptors value on both Ethernet adapters as follows:
a. On the Windows desktop, right-click K2 Media Server (My Computer) and select
Manage . The Computer Management window opens.
b. In the left pane select Device Manager . Device Manager opens in the right pane.
c. In the right pane, expand Network Adapters .
d. Highlight and right-click the Intel® PRO/1000 MT Dual Port Server Adapter .
e. Select Properties . The Properties dialog box opens.
f. Click Advanced tab.
g. In the Settings list, select Performance Options , then click the Properties button.
The Performance Options dialog box opens.
h. In the Property list, select Receive Descriptors .
i. In the Values field, use the up/down arrows to set the value to 1024 . If 1024 is
not available, select a different entry in the settings list, then select back to
Receive Descriptors. This resets the values available in the Values field.
j. In the Settings list, select Transmit Descriptors .
k. In the Values field, set the value to 1024 .
l. Click OK to save settings and close dialog boxes.
m.Repeat this step and set the Rx/Tx Descriptors value on the remaining Ethernet
adapter.
27. Close the Computer Management window.
28. On the Windows desktop right-click My Network Places and select Properties . The
Network Connections window opens.
29. On the menu bar at the top of the window, select Advanced , then Advanced
Settings…
30. Select Control Connection in Connections field.
31. Use the up arrow button, move the Control Connection to the top of the list (TOP
priority - 1st).
32. Ensure that FTP Connection is below the Control Connection.
If not, select FTP Connection, and move it below the Control Connection.
33. Click OK to save settings and close.
34. Install K2 Media Server software. Also install related software, such as SNFS, if
required for the latest upgrade. Refer to your latest K2 Storage System Release
Notes for detailed instructions.