beautypg.com

Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 User Manual

Page 504

background image

504

K2 Storage System Instruction Manual

September 7, 2007

Chapter 11 Installing the Level 30 Storage System

this procedure. If you need trunks, such as on a two-switch system with ISLs, do
the following:

a. Select (Ctrl + Click) the trunked ports. Typically the trunked ports are at the

bottom of the list and are labeled Trk1.

b. Click

Modify Selected Ports

.

If prompted, log in as administrator.

c. For the trunked ports, set Port Enabled to

Yes

. On some switch models, some

ports are disabled by default, so make sure you enable them. Leave Mode as
default of

Auto

.

d. Set Flow Control as follows:

- Set to

Enable

.

NOTE: This setting is for the 2900 series switch. Other switch models might require
a different setting.

e. Click

Apply Settings

.

8. On the Port Configuration page, do one of the following:

• If you do not have trunks, select all ports.

• If you have trunks, select the remaining ports (the ports not trunked).

This setting
varies depending
on switch model.
Set as instructed
in text.