Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 573)

September 7, 2007 K2 Storage System Instruction Manual 573
Configuring RAID
• Gateway Address
• SNMP trap destinations
For L30R RAID, network and SNMP settings are set and stored on the RAID
controller module. For the RAID chassis with two controllers, each controller has its
own network settings and the RAID chassis exists as two entities on the control
network.
The RAID storage device is configured by default for the SNMP community name
“public”. If your site’s policies require using a different SNMP community name,
contact your Grass Valley representative.
To configure these settings, do the following:
1. Launch Storage Utility from the K2 System Configuration application as in the
previous procedure.
2. As prompted, wait while Storage Utility gathers system information, then Storage
Utility opens.
3. In Storage Utility tree view, expand the node for the L30R RAID, right-click the
icon for a L30R RAID controller, and select Configuration | Network Properties .
The Controller Network Settings dialog box opens.
For a L30R RAID chassis with two controllers, you can make settings on both
controllers using this dialog box.