Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 210)

210 K2 Storage System Instruction Manual September 7, 2007
Chapter 5 Installing the Level 3R Storage System
3. Continue with the next procedure to use Storage Utility to configure the storage
and file system.
Leave the Configure K2 Server wizard open while you are using Storage Utility.
When you are done with Storage Utility, you continue with the wizard.
Network Configuration
This page displays the
control network Ethernet
port, and allows you to
configure the FTP/
Streaming network Ethernet
port.
NOTE: This page
does not configure
the iSCSI interface
(media network)
ports.
For Level 3R, since this
server does not take the role
of FTP server, configuring
the second port here for the
FTP/streaming network is
not required.
The top port is the port over which the K2 System Configuration
application is communicating with the K2 Media Server. If correctly
configured, it is already assigned the control network IP address, as
displayed on this page.
Select the other port and click
Modify . A network configuration dialog
box opens. Enter the FTP/Streaming IP address and the subnet mask and
click
Apply .
Click Next .
File System Server
Configuration
Enter the name or IP address of the redundant K2 Media Server (server
1B).
Do not yet click Next. Do not yet enter anything in the File System
Server #2 box.
Click
Launch Storage Manager . Storage Utility opens.
On this page… Do this…