Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 296)

296 K2 Storage System Instruction Manual September 7, 2007
Chapter 7 Installing the Level 10 Storage System
Notes for information about currently supported versions. Then proceed as follows:
• If K2 Storage System Release Notes instruct you to change the firmware on the
switch, do so before continuing. Refer to the documentation you received with
the switch for instructions to change the firmware. Then continue with the next
procedure
“Configuring the GigE switch via the Web interface” .
• If K2 Storage System Release Notes confirm that the version on the switch is a
currently supported version, continue with the next procedure.
30.Type the following, then press Enter :
menu
The main menu opens.
31.From the main menu, choose Reboot Switch and press Enter . When prompted
“Continue Reboot…?', answer yes (press the y key) to proceed. The switch restarts.
32.You can now use the switch’s web browser interface for further configuration, as
instructed in the next procedure.
33.Close the PC terminal program and disconnect the console cable.
Continue with the next procedure “Configuring the GigE switch via the Web
interface” .
Configuring the GigE switch via the Web interface
The following procedure is for the HP ProCurve switch 2900 series. Do not use this
procedure on other switch models.
1. From the control point PC or another PC, make sure that you have a direct Ethernet
cable connection to the switch, with no switches, routers, proxies, or other
networking devices in between.
2. On the PC, open Internet Explorer and type the switch’s IP address in the Address
field, as in the following example.
http://192.168.100.61
This should be the name or IP address as currently configured on the switch.
3. Press Enter to open the switch’s configuration application.
NOTE: The configuration application for the HP ProCurve switch requires Java.
You can also access the switch’s configuration application from the K2 System
Configuration application.
4. In the switch’s configuration application, choose Configuration , then Device
Features .