Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 611)

September 7, 2007 K2 Storage System Instruction Manual 611
Setting up the Nearline GigE switches
b. Choose selection Port/Trunk Settings and press Enter .
c. Press the right-arrow key to choose Edit , then press Enter .
d. Down arrow until at the bottom of the list of ports and select the last (highest
port number) 1 Gig port in the list.
e. Right-arrow over to the Group column.
f. Use the Space bar and set the bottom 1 Gig port to Trk1 .
g. Set the next port up also to Trk1 .
h. Set the next port up also to Trk1 .
i. Press Enter , then right-arrow to Save . Press Enter and revert to previous menu.
26.Select Return to Main Menu and press Enter .
27.From the main menu, tab to Command Line (CLI) and press Enter . The command
prompt appears.
28.Check the version of firmware currently installed on the switch. Type the
following, then press Enter :
show flash
Information is displayed similar to the following example:
HP_iSCSI_switch1# show flash
Image Size(Bytes) Date Version
----- ---------- -------- -------
Primary Image : 3287779 03/15/05 M.08.66
Secondary Image : 3287779 03/15/05 M.08.66
Boot Rom Version: I.08.07
Current Boot : Primary
29.Check the Primary Image Version and refer to your K2 Storage System Release
Notes for information about currently supported versions. Then proceed as follows:
• If K2 Storage System Release Notes instruct you to change the firmware on the
switch, do so before continuing. Refer to the documentation you received with
the switch for instructions to change the firmware. Then continue with the next
procedure
“Configuring the GigE switch via the Web interface” .
• If K2 Storage System Release Notes confirm that the version on the switch is a
currently supported version, continue with the next procedure.
30.Type the following, then press Enter :
menu
The main menu opens.
31.From the main menu, choose Reboot Switch and press Enter . When prompted
“Continue Reboot…?', answer yes (press the y key) to proceed. The switch restarts.
32.You can now use the switch’s web browser interface for further configuration, as
instructed in the next procedure.