Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 450)

450 K2 Storage System Instruction Manual September 7, 2007
Chapter 10 Installing the Level 20R Storage System
Setting up the L20R RAID chassis
Do the following to prepare the L20R RAID storage devices:
• Install the chassis in its permanent location. After mounting the chassis in the rack,
you must secure brackets to the front rail to support the Grass Valley bezel. Refer
to the K2 Lx0 RAID Instruction Manual for rack mount instructions.
• “Connect the L20R RAID Primary and Expansion chassis” on page 450
• “Power on the L20R RAID chassis” on page 451
In addition, you will configure network settings, SNMP settings, and bind RAID
disks. These tasks are part of the K2 System Configuration application and Storage
Utility procedures later in this chapter.
On the L20R RAID, you do not need to manually set a Fibre Channel address ID on
controllers or a chassis address on Expansion chassis.
Also refer to “K2 RAID storage description” on page 659 .
Connect the L20R RAID Primary and Expansion chassis
Connect Ethernet, Fibre Channel, and SAS cabling as shown.
If you have more Expansion chassis than those illustrated, continue the indicated
cabling pattern, connecting additional chassis to DP0.
FLT/LNK
FLT RDY
DP-OUT
PS
FLT CLR DP-IN
FLT/LNK
FLT RDY
DP-OUT
PS
FLT CLR DP-IN
FLT/LNK
FLT RDY
DP-OUT
PS
FLT CLR DP-IN
FLT/LNK
FLT RDY
DP-OUT
PS
FLT CLR DP-IN
BBU IN MODEM
FLT/LNK
HPE FLT
A/L
BACKUP
ACT/LNK
LNK/ACT
FLT
HP
5 4 3 2
RDY
LAN
BAT
MNT
ACS MC DP1 DP0 HP 1 0
BBU IN MODEM
FLT/LNK
HPE FLT
A/L
BACKUP
ACT/LNK
LNK/ACT
FLT
HP
5 4 3 2
RDY
LAN
BAT
MNT
ACS MC DP1 DP0 HP 1 0
Primary
Expansion 1
Expansion 2
DP0
To K2 Medi a
S erver A
To K2 Medi a
S erver B
To NH s erver
(option a l)
To NH s erver
(option a l)
To control port
on GigE
s witch A
To control port
on GigE
s witch B
DP0
Controller 1 Controller 0
To
Exp a n s ion
3
To
Exp a n s ion
3
S A S c ab le connector s a re keyed
to DP IN/OUT port s .
SAS cables