beautypg.com

Configuring the nearline 10 storage system, Prerequisites for initial configuration – Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 User Manual

Page 626

background image

626

K2 Storage System Instruction Manual

September 7, 2007

Chapter 13 Installing the Nearline 10 Storage System

Configuring the nearline 10 storage system

Use the topics in this section to do the initial configuration of the nearline 10 storage
system.

“Prerequisites for initial configuration” on page 626

“Defining a new K2 Storage System” on page 627

“Configuring the NH server - Part 1” on page 629

“Configuring RAID” on page 632

“Creating a new file system” on page 637

“Configuring the NH server - Part 2” on page 638

“Configuring the second NH server for NL10R” on page 639

Prerequisites for initial configuration

Before beginning your initial configuration, make sure the devices of the K2 Storage
System meet the following prerequisites. Refer to sections earlier in this manual for
detailed information. Also refer to

Chapter 14, “Description of K2 Storage Devices”

.

Devices

Prerequisite for nearline 10 configuration

Control point PC

Ethernet cable connected
Control Point software installed
Control network IP address assigned
Network communication over the control network with all other K2
devices
Power on

Ethernet switch

Ethernet cables connected
Control network IP address assigned
Power on