Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 758)

758 K2 Storage System Instruction Manual September 7, 2007
Chapter 18 Administering and maintaining the K2 Storage System
the property page click Launch Storage Utility . Storage Utility opens.You can now
configure the network settings on the controller connected to the selected K2
Media Server.
2. In the Storage Utility, right-click the icon for a RAID controller and select
Configuration | Network Properties . The Network Settings dialog box opens.
3. In the Controller Slot Number field enter 0 and then press Enter . The settings from
controller 0 are loaded into the Controller Network Settings dialog box and are
available for you to modify.
4. Enter the control network IP address and other network settings.
5. You want SNMP trap messages go to the NetCentral server PC, so for SNMP
Configuration enter the IP address of the NetCentral server PC. You can also enter
IP addresses for other SNMP managers to which you want to send SNMP trap
messages.
6. If the RAID chassis has two controllers, in the Controller Slot Number field enter
1 and then press Enter . The settings from controller 1 are loaded into the Controller
Network Settings dialog box and are available for you to modify. Repeat the
previous steps to configure controller 1.
7. Click OK to save settings and close.
8. Restart the RAID chassis to put SNMP configuration changes into effect.