Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 - Manual (Page 464)

464 K2 Storage System Instruction Manual September 7, 2007
Chapter 10 Installing the Level 20R Storage System
3. Continue with the next procedure to use Storage Utility to configure the storage
and file system.
Leave the Configure K2 Server wizard open while you are using Storage Utility.
When you are done with Storage Utility, you continue with the wizard.
Configuring RAID
Use Storage Utility to complete the configuration of the L20R RAID chassis, as
explained in the following topics:
• “Configuring RAID network and SNMP settings”
• “Binding disk modules”
Refer to “Prerequisites for initial configuration” on page 459 to confirm that the
RAID storage is ready for configuration.
Configuring RAID network and SNMP settings
Use the Storage Utility to configure the following settings for the Level 20R RAID
controllers:
• IP address
• Subnet mask
Network Configuration
This page displays the
control network Ethernet
port, and allows you to
configure the FTP/
Streaming network Ethernet
port.
NOTE: This page
does not configure
the iSCSI interface
(media network)
ports.
The top port is the port over which the K2 System Configuration
application is communicating with the. If correctly configured, it is
already assigned the control network IP address, as displayed on this
page.
Select the other port and click
Modify . A network configuration dialog
box opens. Enter the FTP/Streaming IP address and the subnet mask and
click
Apply .
Click Next .
File System Server
Configuration
Enter the name or IP address of the redundant K2 Media Server (server
B).
Do not yet click Next. Do not yet enter anything in the File System
Server #2 box.
Click
Launch Storage Manager . Storage Utility opens.
On this page… Do this…