beautypg.com

Grass Valley K2 Storage System Instruction Manual v.3.2 Sep.24 2007 User Manual

Page 678

background image

678

K2 Storage System Instruction Manual

September 7, 2007

Chapter 16 Managing K2 software

• If you are also restoring the D: partition, select

Yes, I want to restore another

partition or hard disk drive

and then click

Next

.

The Partition or Disk to Restore page opens. Continue with the next step in this
procedure.

14. Select

Database (D:)

and then click

Next

.

The Restored Partition Location page opens.

15. Select

Database (D:)

and then click

Next

.

The Restored Partition Type page opens.

16. Leave the selection at

Primary

and then click

Next

.

The Restored Partition Size page opens.

17. Leave settings at their defaults. The size reported in the upper pane is the size

detected of the actual D: partition. This should be the same as that reported in the
Partition size field in the middle of the page. Free space before and Free space after
should both be reported at 0 bytes. Click

Next

.

The Next Selection page opens.

18. Select

No, I do not

and then click

Next

.

The Restore Operation option page opens.

19. Do not make any selections. Click

Next

.

The “…ready to proceed…” page opens.

20. Verify that you are restoring the correct partition or partitions. Click

Proceed

.

The Operation Progress page opens and displays progress.

21. When a “The data was successfully restored” message appears, click

OK

.

22. Click

Operations | Exit

to exit the Acronis True Image program.

The K2 Media Server restarts automatically.

23. Remove any CD currently in the CD drive while the K2 Media Server is shutting

down.

24. Upon restart the Windows Setup Wizard automatically opens. Do Windows setup

as follows:

a. Enter in Windows Product Key and click

Next

.

The Product Key is on a sticker on the top of the machine near the front right
corner.

b. Enter the name of the machine.

For a K2 Media Server name, enter the Serial Number (located at right side and
rear).

The password is pre-set to the factory default. Leave the password as is.

c. Click

Next

d. Set Time and click

Next

.

Windows loads network components and restarts the K2 Media Server.