Table of system faults, System fault list – ATEIS IDA8 User Manual
Page 88
ATEIS - IDA8
88
© 2012 ATEÏS
Name
Description
3. Line A/B short, a circuit outside the speaker zone output
connector is shorted, and no sound comes out. This fault may
damage the amplifier.
The current between the speakers and amplifiers has a leakage.
The voltage of EVAC input is not in the range (when the evacuation
input is set to "contact mode").
This fault happens when one or more IDA8C's or IDA8S's over Ateis
Net lose the connection.
Note: Global Ateis Net Broken only for global net IDA8.
The fireman microphone has an error.
The IDA8C/S can't communicate with the VOX@NET server.
1. It shows "Backup Device Offline" when a backup device can't
communicate.
2. It shows "Operation Mode Fail" for:
RU device is turned off.
The incorrect wiring between the RU and the IDA8.
The peripheral devices (PSS AS/PPM AS/URC AS/...)
can't communicate with the IDA8C/S.
The URGP device monitor is out of tolerance
There is a hardware error of peripheral devices, such as the
microphone/speaker on a PSS.
The file CRC check code fails if the file monitor option is enabled.
The Modbus client can't communicate.
The IDA8 gets the reference value which is too low.
A normal amplifier fails and is replaced by the backup amplifier.
One of the local ATEIS net port has broken.
Global AteisNet Backup Mode
One of the global ATEIS net port has broken.
Note: Only for global net IDA8.
If using a redundancy unit, the IDA8 will enter the bypass mode
when a Bypass Mode fault occurs. If not, the IDA8 will enter in that
mode only when the "Bypass Input" line on the rear panel has
broken.
The "Fault Define Security" component trigger.
The "Fault Define Security" component trigger.
The Modan client can't communicate.
All the NTP server can't communicate.
The normal amplifier measure out of tolerance.
The backup amplifier measure out of tolerance.
4.1.7.1.1 Table of System Faults
Name
Description
An error occurred in the Nand flash inside IDA8C/S.
There is an internal error of I2C communication between micro
controllers.
There is an error of communication between the main CPU in the
IDA8C/S and the Net card.
There is an internal error of communication between micro
controllers inside devices.
The structure of the configuration is not compatible with the current
firmware.
108
109
111
113
114
115
116
118
117
120
121
121
122
123
123
124
125
125
126
127
127
89
89
90
91
91