ATEIS IDA8 - Manual (Page 246)

ATEIS - IDA8 246
© 2012 ATEÏS
4.2.12.4 Configuration
To make CDPM work it need to edit configuration using Ateis Studio. Following sections are about
configuration editing.
The example here is IDA8, the configuration is the same for ESC, LAPG2T and other Ateis Audio
Processor.
Create CDPM Object
Open or create a Ateis studio configuration file, in the [Device] design window, create audio
processor and CDPM object:
1. Drag IDA8C to design window to create audio processor object.
2. Drag PPM AS to design window to create CDPM object. Note: PPM AS, PCP, PSC and CDPM
share the same object.
3. Wiring to connect green pins between CDPM object and audio processor.
DSP component configuration
It need to route audio from CDPM to paging component for paging processing. See the following
example: