Ateis net deploying – ATEIS IDA8 User Manual

Page 370

Text mode
Original mode

ATEIS - IDA8

370

5.4.4

Ateis Net Deploying

This function allows the user to configure the networking state of devices on Ateis Net. Connecting the
physical units together through the Ateis Net port and the identification must be assigned to each device
when they are set up for the first time. To do this, you need to perform the "config IP" function by
following the steps listed below:

1. Connecting the Ethernet to the first unit and obey the wiring rules that the Ateis Net Port is B to A

and A to B connection.

2. Open the Device Management Window.

3. Search and Connect to the device. For step by step guide, see "

Device Management > Search and

Connect

4. Select the device which will be the master unit and click [ATEIS NET Deploying] to execute the

procedure. A Machine Configuration window appears showing "Start configure IP".

364