ATEIS IDA8 User Manual

Page 563

Components of Audio Processor

563

Code:

A code is a zone combination so called a selection of zones. The figure above is an
example, the zone combination of the code is (Z1, Z2, and Z3) which means zone 1, 2
and 3 will be selected when requesting a page.

All:

Selects all zones for the code.

Zone Selection:

Check the checkbox to specify a zone to be included in a code. The table lists all of the
zones of a paging component under the same Ateis Net.

Source Type:

Specifies the source type to bind with the paging event. When a paging event is active
(i.e. A paging request is acknowledged by the IDA8, you can say the zones are
occupied by the audio source bound with that paging event). This info (zone:occupied
source) is used in some logic or procedure of paging component implementation for
giving different results for the user. See the next sections for more details about how the
audio source is also being used.

Priority:

A priority value per zone along with the code. If more than one source is attempting to
page the same zone, IDA8 uses the priority value to decide which source is allowed to
occupy the zone for paging.

Note: The smaller the value the higher the priority.

Priority Visible:

A checkbox to show or hide the priority setting inside the grid.

Button All:

Set the same priority value for all zones. The grid for entering the priority value for
applying to all zones is located by the [All] button.