Global settings – ATEIS IDA8 User Manual
Page 139
Product Features
139
© 2012 ATEÏS
4.1.7.6
Global Settings
There are global settings listed below:
Enable Monitor:
A check box used to enable or disable the monitor function.
Enable Leakage:
A check box used to enable or disable the leakage detect function.
Leakage Threshold(1k ohm):
A threshold value for the leakage detection. If the leakage impedance is lower than this value, the
fault Leakage Occurrence is detected.
Leakage Calibration:
If the system detects a leakage fault, but the problem wasn't found in the circuit after performing a
propriety check, it needs to perform a leakage calibration to confirm the monitor function is working
properly.