Tone settings – ATEIS IDA8 User Manual
Page 140
ATEIS - IDA8
140
© 2012 ATEÏS
4.1.7.7
Tone Settings
In the lower part of the window [Monitoring(Matrix Mode)-IDA8C/S X ], There is a page [Tone Settings] for
configuring the tone signal which is utilized for monitoring. There are two types of settings:
Zones with 0dB:
If the audio signal from Amplifier Zone Output is not returning to the IDA8C/S for monitoring, this
allows the user to mix a tone into that signal for further detection. You can change this setting in the
[Zone Settings] tab and the [Mode] field. There are parameters of settings:
Zone:
Indicates the zone number of parameters.
Mute:
Mutes the tone signal.
Level(dB):
The level of the tone signal.
Frequency(Hz):
The frequency of the tone signal.
Zones with 100V:
Frequency:
The frequency of the tone signal.
Enable 1K Tone: