Operation notice, Two dnm on the same pdc – ATEIS IDA8 User Manual
Page 189
Product Features
189
© 2012 ATEÏS
4.2.2.6
Operation Notice
Once the calibration is successful, don't adjust the level in the rear of DNM component (ex: Monitor Out
C's level or amplifier gain, etc.), but the level can be adjusted which is front of the DNM component (ex:
Input A level or PC output volume, etc.).
4.2.2.7
Two DNM on the Same PDC
If the system needs to use more than one DNM and connect the DNM units on the same RS485 port,
the user should assign DNM units with different IDs.
1. For each DNM, choose the remote type and manually enter its SN then click "Plug-In". Note: If you
lose the SN and cannot find the number sticker, connect only the one you want and click [Refresh] to
show its Serial Number.