Circuit leakage – ATEIS IDA8 User Manual
Page 141
Product Features
141
© 2012 ATEÏS
Enables 1K tone for monitoring. If this option is on, during the Start Time and the End Time, a
1K tone signal will be sent to the amplifier for monitoring.
o
Start Time:(hh:mm)
The time to start 1K tone sending.
o
End Time:(hh:mm)
The time to stop 1K tone sending.
4.1.7.8
Circuit Leakage
Circuit Leakage is caused when the AMPO +/- conducting to the ground. For example, the isolation of
a speaker's wire is broken.
Leakage causes the gradual loss of voltage. Once it is detected, the IDA8C will open the relay of the
leakage zone.
The following messages will display on the touch panel of the IDA8C and in the Ateis Studio. See
104