Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 94)

94
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Area
Configuration
Depending on the
configuration that is loaded
onto your TPS1100 instrument, you
may not see some or all of the
options referred to below. See your
Leica Geosystems dealer for more
information about the configuration of
your instrument.
Configuration Editor
Start the Configuration
Editor from the
"Measure Point" dialog.
Log File
Set to ON, the program will record
measurement data in a log file in the
format
described on the last page of
this chapter.
Log FlName
Enter the Log File Name.
Meas. Job
Selection of the measurement job for
recording measurements.
Data Job
Selection of the data job containing
the fix point coordinates (control
data).
The "Configuration Editor" sets
parameters for further program
operations:
Two Faces
YES for dual-face measurement,
NO
for single-face.
Code
Enter the block identification code for
recording the area results (max. eight
alpha numeric characters)
AREA\ Configuration
Two Faces : NO
Code : 36
Log File : OFF
Log FlName: AREA.LOG
Meas Job : MEAS.GSI
Data Job : DATA.GSI
CONT DEFLT INFO
MC
QUIT