Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 253)

253
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Monitoring
>< Measures loops of all points in
face I followed by all points in face
II in the inverse sequence of
points. Number of loops equals the
number of repetitions.
[1: I II 2: I II 3: I ...]
[ A B C C B A A B C C B A A B C ...]
>> Measures a set of all points in
face I followed by all points in face
II in the same point order. Number
of sets equals number of
repetitions.
[1: I II 2: I II 3: I ...]
[ A B C A B C A B C A B C A B C ...]
> Measures all repetitions to each
point before moving to next point.
Only in face I.
[A I B I C I …]
[1,2,3 1,2,3 1,2,3 …]
Selecting Points, continued
Go to Main menu after all
points have been activated and
MeasMethod selected.
Calls the Measurement menu
for first time point
measurement (See measurement
menu).
Calls the Point Selection ( See
Selecting the Points to be
Measured).
Measurement menu
MONIT\ Learn Point
Point Id : 1000
Refl. Ht. : 0.000 m
Hz : 281°47'05"
V : 92°15'36"
Horiz.Dist: 256.4442 m
ALL DIST REC CONT DONE
MC
I<>II QUIT
If the measurement file already
contains points, then when this
function is called you will be asked
whether the points are to be
overwritten.
For the instrument to learn a point
the prism must be targeted manually.
Triggering the distance measurement
then initiates a distance
measurement and a precise
determination of the angle.