Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 55)

55
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Free Station
Target Point
Enter the target point number and
height of the reflector. Displays the previous point
from the list of points you
entered. Note that this key will not be
available until there is at least one
point in the list.
Displays the next point in the
list of points you entered.
Note that this key will not be available
until there is at least one point in the
list.
Search and display the
coordinates of the point found
in the active data job.
Run the calculation.
Note, the key
will be
assigned after sufficient
measurements were taken to
calculate a position.
Search the coordinates of the
target point from the
coordinates of the point entered in
the active data job and go to the
measure mode.
Define a list of target points
and the measurement
sequence. For further use: selection
of points from the list is possible.
Point List
Enter a maximum of 10 points. The
same point can be retrieved several
times.
The same point number can be used
several times without new input.
Return to dialog "Target
Point"
FreSt\ Point List
Point 1 TAR01
Point 2 TAR02
Point 3 TAR03
Point 4 TAR04
Point 5 TAR05
Point 6 TAR06
MC
QUIT
Point 7 TAR07
Point 8 TAR08
Point 9 TAR09
Point 10 TAR10
CONT
FreSt\ Target Point
Point Id : 1
Refl. Ht. : 1.555 m
MC
QUIT
SEARC LIST <-- --> VIEW CALC