Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 27)

27
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Resection
Dual-face Measurement
In the dual-face mode, the program
will prompt for measurements in both
faces. When both measurements are
taken, the program will check the
difference between the two. If the
difference in angle is within 27'
(0.5 gon) and the difference of two
measured distances is within 0.5 m
(1.64 ft), the observations will be
averaged.
These tolerances are used to avoid
errors in target identification.
If exceeded an error message will be
displayed.
Store the current
configuration and proceed to
the dialog "STATION DATA".
Set the value to the default
Displays date and version.
Exit the program.
Log FlName
Enter the Log File Name.
Meas. Job
Selection of the measurement job for
recording measurements.
Data Job
Selection of the data job containing
the fix point coordinates (control
data).
UserDisp.
YES The same display mask as the
one used in the system
measurement dialog (MEAS)
is used for measurements with
"RESECTION".
NO The "RESECTION" default
display applies.
Log File
Set to ON, the program will record
measurement data in a log file as
described in
chapter "Log File".
Configuration Editor, continued