Leica Geosystems TPS1100 Professional Series - Reference Manual - Manual (Page 43)

43
TPS1100 - Appl. Prog. Ref. Manual 2.2.0en Stakeout
∆∆∆∆∆
Hz
Difference in Hz circle reading
between the actual horizontal
direction and the calculated direction.
∆∆∆∆∆
Dist
Difference in horizontal distance
between the measured and
calculated distance.
∆∆∆∆∆
Height
Difference in height between the
measured reflector point and the
stakeout point, expressed both
numerically and as CUT/FILL.
Elevation
Elevation of the measured target
point.
Simultaneously measure and
record data in the
measurement job.
Measure a distance.
Record the measurement in
the measurement job.
Acquire the next point to
stake.
Enter target data.
Re-position the telescope on
the target. Note, this function
is only available for motorized
theodolites.
Change stakeout
method. For more
information refer to chapter "Select
Stakeout Method".
Generate a plot of the
stakeout data. For
more information refer to chapter
"Plot".
Exit the program.
Polar Stakeout, continued