INFICON STC-2000A Thin Film Deposition Controller Operating Manual - Manual (Page 75)

p
STC-2000A DEPOSITION CONTROLLER
y
NON-SEQUENCING MODE: SELECTING THE ACTIVE FILM
NON-SEQUENCING MODE Runtime screen.
NON-SEQUENCING MODE Main Menu (note missing REVIEW PROCESSES and change from NEXT PROCESS
to NEXT FILM). (See section 2.1 for description of modes.)
To select the next active film in non-sequencing mode, begin by pressing the NEXT FILM key on the Main
Menu above. This action will result in the following numeric entry screen. The entry made here will
become the active film following the next START sequence. The BA
c K key returns to the Main Menu
without change. The ENT er key accepts the entry and returns to the Main Menu. The numeric entry, if
made, will show itself within the "NEXT FILM" key legend and on the runtime screen following the text
"NEXT FILM:" (see above).
When the running, this will become the active film and appear after the text "FILM".
Film Parameter values after memory purge: [non-SEQ adds "Final Thick Limit=0.0 KÅ"]
See Section 1.8 for Programmable Parameter Lists and Programmable Parameter Dependency Lists.
See Section 2.2 for Menu Parameter Values & Programming After Memory Purge and ...After Factory
Restored Memory.
Film parameter difference (from purge) with a factory restore:
max power limit set to 50% (purge = 0%).
Related System Configuration values after memory purge:
LCD Contrast Medium
Password Lock # 0
Run number 0
Recorder Functions Rate
Recorder Output Channel 1
I/O Slot X Type Unused
Memory Module IFC Off
Related System Config differences (from purge) with factory restore has:
recorder function set to show POWER. << >>
SECTION 3.XX page 75 of 292