INFICON STC-2000A Thin Film Deposition Controller Operating Manual - Manual (Page 39)

p
STC-2000A DEPOSITION CONTROLLER
y
IEC switch/connector
A14
AC power supply header B11
A
B
C
D
E
F
G
HI
J
K
L
M
10 11 12 13 14 15 16 17 18 19 20 21
DC power supply header H11
Source/Sensor Card A15-I15
Input Card (I/O 1) A16-I16
Output Card (I/O 2) A17-I17
Input Card (I/O 3) A18-I18
Output Card (I/O 4) A19-I19
Host Port (RS232) Bd. A14-H14
Memory Mod. Interface Bd. A14-H14
Speaker G20
Bus Board J10-J20
CPU/Main (CSUB) Bd. L10-L20
(Remote) Hand Controller Bd. L18-L20
Ferrite Assemblies A10, A12
LCD Display/Touch Screen M10-M20
Pendent:
Also called a hand controller, may be connected by means of the front panel jack labeled Hand
Controller when certain front panel functions need to be duplicated remotely or when intending to utilize
the Manual mode. When not in use, the pendent may be left plugged into the STC-2000A unit or it may be
removed. The pendent does not contain any active electronics nor is it polled to check for its presence.
SECTION 2.XX page 39 of 292