INFICON STC-2000A Thin Film Deposition Controller Operating Manual - Manual (Page 175)

p
STC-2000A DEPOSITION CONTROLLER
y
I/O SETUP Edit Menu
SECTION 5.12
Pressing
the EDT (edit) key produces the I/O Setup Edit menu as seen in
figure 5.4. At this menu level, there are 3 edit options (navigation aside): CHG (change line currently in the
2
nd
[editing position] of the displayed rung list section), INS (insert a new [empty rung] line before the line
in the editing [2
nd
] position of the displayed rung list section), and DEL (delete line currently in the 2
nd
,
editing position of displayed rung list section).
DEL This key deletes the rung (line) that currently appears in the EDIT position (centered rung
with -
↓↓- above it, see figure 5.3 or 5.4). The END rung cannot be deleted. The next
consecutive rung assumes the place and line number of the rung (line) now vacated by
the deletion. All subsequent rungs (lines), if any, are also moved up with the line number
values decremented by 1.
INS This key inserts an empty rung (line) into the I/O setup program list with each key press.
The new rung (line) is inserted just ahead of the rung (line) that is in the current edit
position (see figure 5.4). The new rung assumes the EDIT position while previous EDIT
position contents are advanced by one: in screen position, line number value and I/O list
position.
In other words, the INS key inserts an empty rung just before the rung in the current
EDIT position. After pressing the INS key, the new empty rung will occupy the EDIT
position (2
nd
line) while the former rung is moved to the bottom (3
rd
) line with the line
number incremented by 1. After a rung is inserted, use the CHG (change) key to alter the
empty rung contents.
BAK: Quits the I/O SETUP Edit menu and returns to the I/O Setup main menu.
CHG: Can be used to modify (change) the contents of the rung (line) currently in the edit
position (2
nd line of displayed rung list section). Used for entering or changing function
commands/operators within the rung. The CHG (Edit/Change) mode is the mode in
which you will write your programs. You can construct rungs by adding/subtracting
tokens (see table 5.1). The CHG (Change) key sub-menus are discussed in the next
section (section 5.13).
line# of 1 st
displayed
rung
1 st
displayed
rung
line# of 3 rd
displayed
rung
Rung 009 is in the position that selects it for editing.
Dashed box includes edit line# and rung line in edit
3 rd rung (token string)
osition (2 nd of 3 displayed list items). p
EDT (edit) MENU
The format of each rung as it appears in the edit/view window is as follows:
Rung (Line) # :
Token string of Rung
The format for the middle rung, which is the edit/change position, has the same format except for dashes
and down arrows:
SECTION 5.XX page 175 of 292