INFICON STC-2000A Thin Film Deposition Controller Operating Manual User Manual
Page 224

p
STC-2000A DEPOSITION CONTROLLER
y
Parameter 38
rate from sensor 1
access index:
RATE1
Value Range
0 To 9999 [integer]
Units
Deci-angstroms/sec
The rate reported from sensor 1 with 9999 representing 999.9 Å/S. 1 of 8 in a contiguous block. Associated
card needs to be physically installed and enabled before a reboot.
______________________________________________________________________
Parameter 39
rate from sensor 2
access index:
RATE2
Value Range
0 To 9999 [integer]
Units
Deci-angstroms/sec
The rate reported from sensor 2 with 9999 representing 999.9 Å/S. 2 of 8 in a contiguous block. Associated
card needs to be physically installed and enabled before a reboot.
______________________________________________________________________
Parameter 40
N.A.
______________________________________________________________________
Parameter 41
N.A.
______________________________________________________________________
Parameter 42
N.A.
______________________________________________________________________
Parameter 43
N.A.
______________________________________________________________________
Parameter 44
N.A.
______________________________________________________________________
Parameter 45
N.A.
______________________________________________________________________
Parameter 46
xtal life/status from sensor 1
access index:
XLIFE1
Value Range
0 To 99
Units
Percent
xtal life/status from sensor 1. This parameter along with the following seven parameters form a contiguous
block of 8. Associated card needs to be physically installed and enabled before a reboot.
______________________________________________________________________
Parameter 47
xtal life/status from sensor 2
access index:
XLIFE2
Value Range
0 To 99
Units
Percent
xtal life/status from sensor 2. 2
nd
in a contiguous block of 8. Associated card needs to be physically
installed and enabled before a reboot.
______________________________________________________________________
Parameter 48
N.A.
______________________________________________________________________
Parameter 49
N.A.
______________________________________________________________________
SECTION 6.XX
page 224 of 292