INFICON STC-2000A Thin Film Deposition Controller Operating Manual - Manual (Page 187)

p
STC-2000A DEPOSITION CONTROLLER
y
We will do the same thing again, press the IN key again and enter an I0. The display will now look like
the 1 st screen in Figure 5.10
Figure- 5.10: Entering Input Functions and Starting Output Function.
Entering The Program
We now want to complement the second I0. This is done by selecting the NOT function by
pressing the NOT key (! appears). Now we want to OR these two terms together. Select OR by pressing
the OR key (¦ appears). See the 2
nd screen in figure 5.10 for these two entries (the MOR E key navigates).
The last function to enter is the output to which the result is sent. Because we have defined relay 8 for this,
we want to enter an
O15. See Table 5.4, for a list of all States and Events. Press the OUT key to select
an Output function. You will be prompted for the ID number. Enter a 15 for the ID#. Press the 10 key
once for the 1, and the 1 key five times for the 5 (See the 2
nd screen in figure 5.10). Follow the digit entries
with the ENT key to accept the digit entries. The display will look like figure 5.11.
Figure- 5.11: Finishing the Output Function Entry.
Entering Tokens
Press (rung) ENT to accept complete rung. Result is in screen 2 of figure 5.11. Rung 012 is now
finished and saved as part of the I/O Setup program. Use BAK to leave the CHG/EDT line process. The
relay number 8 will close at this point (you can probably hear it click on). The ID (I/O program checksum)
should be: B07587. This finishes entering this I/O program. Return to the RunTime screen by pressing the
fixed STATUS key.
SECTION 5.15 Example 2 - Factory Installed I/O Program
This I/O program is the one that is shipped standard with the STC-2000A. Its functions are:
Factory Set Outputs
Output 1 Crystal Fail - This relay provides a contact closure whenever the film program stops because of
mapped (selected) sensors failing to operate properly (or sensors exceeding the user defined
operating range). A STOP: XTAL message will be displayed on the LCD display to alert the user
of this condition.
Output 2 Source #1 Shutter Relay - This relay is intended to provide control of the source shutter. It is
generally activated during the deposition phase when source #1 is active.
Output 3 Xtal 2 Select - Output 3 is enabled when sensor 2 is an active sensor.
Output 4 Thickness Setpoint - This relay provides a contact closure whenever the accumulated thickness
display value equals or exceeds the thickness setpoint parameter value.
Factory Set Inputs
SECTION 5.XX page 187 of 292