INFICON STC-2000A Thin Film Deposition Controller Operating Manual - Manual (Page 43)

p
STC-2000A DEPOSITION CONTROLLER
y
switch is not accessible. Also, use to generate ACCEPT key if not
present (e.g. to end the Test mode when in the Test mode).]
*NOTE: Of primary concern when connecting evaporant power supply to the sensor card.
Dependencies
[Prerequisite states that must be in effect for the following parameters to be fully functional]
The Power Related Film Parameter Dependency List is:
Max Power Dwell
Film Parameter: Abort Max Power SW = ON
The Power Related RunTime Screen parameter Dependency List is:
(Crystal Quality Indicator Select) L/Q, Loop x, Qual xx Film Parameters
(Manual mode)
Running Process + Pressing fixed front panel MANUAL key +
attached Pendent (or on 2
nd STATUS screen: , , zero CH x)
(process start) . Perform Carry out the following 2 key sequence up to 3 times.
Press the fixed front panel START key + 1 of 4 touch panel keys:
Break Wait, Next Layer, Restart Layer, Reset / Start Process
(see figure in end of section 2.7). Use the appropriate touch key for the
task at hand. If unsure, use Reset / Start Process key in all 3 sequences.
Please read and understand this manual before starting a live process.
SECTION 2.XX page 43 of 292