Yokogawa Standalone MW100 - Manual (Page 96)

2-8 IM MW100-01E
2.4 Connecting Signal Wires
Attaching the Plate with Screw Terminal and Plate with Clamp Terminals for Current
A screw terminal plate (model 772080, sold separately) can be attached to the 10-CH
Medium Speed Universal Input Module, the 10-CH Pulse Input Module, and the 10-CH,
High Speed Digital Input Module. In addition, the dedicated plate with clamp terminals for
current (model 772081/772082/772083, sold separately) can be attached to the 10-CH
Medium Speed Universal Input Module.
The plate with screw terminal is attached and removed in the same manner as the screw
terminal block. Note that the terminal arrangement is different than that of the clamp
terminal plate. The proper arrangement is shown on the back of the terminal covers, so
be sure to replace the cover along with the terminal plate.
For the handling of the plate with screw terminal, see “Handling the MX100/MW100 10-CH
Plate with Screw Terminal” in IM MX100-77E.
For the handling of the plate with clamp terminals for current, see the MX100/MW100
Setting Up the Plate with Clamp Terminals for Current (772081/772082/772083) (IM MX100-
78E.)
100mA
10
1
2
5
4
8
7
11
10
14
13
1
2
5
4
8
7
11
10
14
13
Attachment
screw
Plate with screw terminal
Attachment
screw
Plate with clamp terminals for current
Screw Terminal Block
The 10-CH Medium-Speed Universal Input Module, 10-CH Pulse Input Module, and
10-CH High-Speed Digital Input Module allow you to remove the terminal plate and
connect a 10-channel screw terminal block (accessory sold separately, M4 screws) that
can be attached to a DIN rail (see the figure below).
CH 1
CH 2
CH 3
CH 4
CH 5
CH 6
CH 7
CH 8
CH 9
CH 10
b B A
Terminal cover
b +/A
–/B
10-CH screw terminal block (772061)
Connector cover
Attachment screw
for connector cover
10-CH, Medium-Speed Universal Input Module/
10-CH, Pulse Input Module/
10-CH, High-Speed Digital Input Module
DIN rail
Latch lever
(Pull down to detach.)
10-CH screw terminal
block (772061)
Connection cable
between the input module
and screw terminal block
(772062-0XXX*)
* Length: 050 or 100 cm.
Attachment to a DIN Rail
Loosen the attachment screw for the connector
cover and open the connector cover.
Attachment screw
Attachment screw