Yokogawa Standalone MW100 - Manual (Page 44)

1-30
IM MW100-01E
E-Mail Function
Notification can be made of alarm occurrences and creation of data files by e-mail.
Two recipient locations can be specified. Multiple addresses can be specified for each
recipient location.
For details about e-mail contents, see chapter 5, “Specifications.”
E-Mail Types
The following types of e-mail can be generated.
E-Mail Type Operation and Contents of E-Mail
Alarm notification E-mail is sent when measurement or MATH alarms are activated or cleared.
Contents:
Channels, levels, and types of alarms that were activated or
cleared, instantaneous values of measurement and MATH
channels (when selected), transmission request time
Report notification Sends hourly, daily, weekly, and monthly reports via e-mail. When
measurement is started, the report is sent even if recording is stopped.
Contents:
The hourly, daily, weekly, or monthly (selectable) maximum,
minimum, average, integral, or instantaneous values (selectable),
report start and stop date/times, and report status
File creation
notification
E-mail is sent when a measured, computed, or thinned data file, manual
sample file, or report file is created.
Contents:
Created file name and time of send request
Notification of
remaining space
on media
E-mail is sent when the remaining time on the CF card is determined to be
less than the specified time.
Contents:
Total and remaining space on CF card, and the time of send
request
Notification of
power ON
E-mail is sent when the power is turned ON.
Contents:
Time power was cut and turned ON
System error
notification
E-mail is sent when an operation error occurs.
Contents:
Error number and message, and time of send request
Fixed time report E-mail is sent every specified time interval.
Contents:
Instantaneous values of the measurement and MATH channels
(when selected) and the time of send request
Reference time setting: Set in units of one-minute between 00:00 and 23:59
Time interval:
Select 1, 2, 3, 4, 6, 8, 12, or 24 h
Test E-mail is sent when test is executed.
If a mail send request occurs during sending of another message, the request
is ignored.
1.3 Functions of the Main Module