Yokogawa Standalone MW100 - Manual (Page 138)

3-16 IM MW100-01E
Daylight Saving Time Setting
1. From the top screen, click System Setting > Daylight Saving Time Setting.
2. Select the Daylight Saving Time check box. The Summer time and Winter time
function is enabled.
3. Select a starting month, week, and day of the week for the start of Summer time
in the Start Time box. Enter a start time in the box.
4. Select an ending month, week, and day of the week for the end of Summer time
in the End Time box. Enter an end time in the box.
5. Click the Apply button. The Summer time and Winter time start times are enabled.
Other Settings
This is for entering the MW100 unit number, units of temperature, alarm hold, rate-of-
change interval, and strain initial balance settings.
From the top screen, click System Setting > Other Settings.
Unit Number
1. Enter a number from 0 to 89 for identifying the MW100 unit in the Unit No. box.
2. Click the Apply button. This enables the setting changes.
Temperature Unit
1. Select Celsius deg C or Fahrenheit deg F in the Temperature Unit list.
2. Click the Apply button. This enables the setting changes.
Alarm Status Hold
1. If the Hold check box is selected, alarms are held.
2. Click the Apply button. This enables the setting changes.
For a description of the alarm hold/non-hold, see “Alarms” in section 1.3.
Rate-of-Change Interval
1. Enter the measurement count that determines the interval in the Increase
Interval box under Rate-of-Change Alarm.
2. Enter the measurement count that determines the interval in the Decrease
Interval box under Rate-of-Change Alarm.
3. Click the Apply button. The settings for each item are applied.
For a description of the rate-of-change interval, see “Alarms” in section 1.3.
3.3 System Settings