14 network utility settings, Dns client settings, Ftp client settings – Yokogawa Standalone MW100 User Manual
Page 171: 14 network utility settings -49, Dns client settings -49 ftp client settings -49, App index
3-49
IM MW100-01E
Setting and Data acquisition
1
2
3
4
5
App
Index
3.14 Network Utility Settings
Setting Mode
DNS Client Settings
1.
From the top screen, click
Communication Setting > DNS Client Setting.
2.
In the
Primary and Secondary boxes under DNS Server, enter the IP addresses
of the respective DNS servers.
3.
In the
Primary and Secondary boxes under Domain Suffix, enter the domain
name.
4.
Click the
Apply button. The setting changes take effect.
FTP Client Settings
1.
From the top screen, click
Communication Setting > FTP Client Setting.
2.
Select the
Client function check box to enable the function.
3.
Enter the delay (in minutes) from file creation to file transmission start in the
Time
Shift box.
Set the delay time shorter than the recording data length.
4.
Select the number of the destination to be set in the
Destination list.
You can set up to two destinations. Number 1 is primary and number 2 is secondary.
5.
Enter the FTP server name in the
Server Name box.
6.
Enter the FTP server port number in the
Port Number box.
7.
Enter the user name of the FTP server in the
User Name box.
8.
Select the
Password check box, and then enter the user password in the
Password box.
If you do not select the check box, you cannot enter the password.
9.
Enter the folder to be accessed when opening a connection in the
Directory box.
10.
You can select the
PASV Mode check box to use FTP passive (PASV) mode.
11.
Click the
Apply button. The setting changes take effect.