Computation operation settings, Computation operation settings -20 – Yokogawa Standalone MW100 User Manual
Page 142
3-20
IM MW100-01E
Computation Operation Settings
From the top screen, click
System Setting > MATH Setting.
MATH Interval Settings
1.
In the
Interval Group list, select the interval group number. The measurement
interval is set to the interval assigned to the selected group number.
Note
If multiple interval groups are specifying the same measurement interval, specify the largest
number for the interval group number that you select.
MATH Operation Settings
2.
Select +Over or –Over in the
Error Data list.
TLOG and CLOG Computation Operation Settings
3.
Select units of integration in the
Sum Scale list.
4.
Select Over (computation stop) or Rotate in the
PSUM Overflowed Data list.
Measurement Input Settings
5.
Select Error (MATH error) or Skip in the
Abnormal Input Data list.
6.
Select Over (handle as an overflow value), Skip, or Limit in the
Overflowed Data
list.
TLOG and CLOG Input Settings
7.
Select Error (MATH error) or Skip in the
Abnormal Input Data list.
8.
Select Error (MATH error), Skip, or Limit in the
Overflowed Data list.
9.
Click the
Apply button. This enables the settings changes.
For processing upon MATH errors, see “Processing Computed Results with Abnormal Input
Values or Overflow Values” in section 1.15.
3.4 Setting Acquisition Conditions for Measured/Computed Data