Yokogawa Standalone MW100 - Manual (Page 92)

2-4 IM MW100-01E
2.3 Attaching the Modules
WARNING
To prevent electric shock and instrument breakdown, do not connect the power
supply to the main module when attaching modules.
Preparing the Base Plate
The accessory brackets are attached in order to attach the MW100 main module to the
base plate.
Remove the base block bracket Attach the bracket that came with the MW100
Attachment Procedure
1. Check that the power supply is not connected to the main module.
2. Align the connector on the rear panel of the module to the connector at the desired
position of the base plate and insert the connector. Attach the main module to the
right-most position on the base plate.
When the connectors are correctly connected, the guide pin on the rear panel of the
module is inserted into the guide hole on the base plate. In addition, the module is
secured to the base plate with the latch lever locking in place at the bottom section of
the base plate.
3. Fasten screw(s) (M3) at the top of the input/output modules.
To remove the module, loosen the attachment screw, pull down on the
latch lever on the rear panel of the module, and pull the module straight
from the base plate.
Guide pins
Main module
Screw holes
Guide holes
Module connector
Base plate
Base plate
Latch lever
(pull up to remove the module
from the base plate)
Base plate connector
cover*
(accessory sold
separately)
Input/Output module
Module attachment
screw
* Can be attached
by hooking the
top section of
the cover to the
top edge of the
base plate and
pressing down
on the lower
section of the
cover.