HEIDENHAIN MANUALplus 4110 - Manual (Page 93)

HEIDENHAIN MANUALplus 4110 93
4.3 Single Cut Cy
cles
Linear machining at angle
Call the single-cut menu.
Select the "Linear machining at angle" cycle.
With return soft key:
Off: When the cycle is completed, the tool remains at
the cycle end position.
On: Tool returns to the starting point.
Linear machining at angle
MANUALplus calculates the target position and moves the tool on a
straight line from the starting point to the target position at the
programmed feed rate. When the cycle is completed, the tool remains
at the cycle end position.
Contour linear, at angle ("With return")
MANUALplus calculates the target position. The tool then approaches
the workpiece, executes the linear cut and returns to the starting point
at the end of cycle (see figures at right). Cutter radius compensation is
taken into account.
Cycle parameters
 X, Z starting point
 X1, Z1 starting point of contour (if "With return" is active)
 X2, Z2 contour end point
 A starting angle —range: –180° < A < 180°
 T tool number
 S spindle speed / cutting speed
 F feed per revolution
Parameter combinations for defining the target point:
„ X2, Z2
„ X2, A
„ Z2, A
Cycle run (if "With return" is active)
1 Calculate the target position.
2 Move on a straight line from X, Z to contour starting point X1, Z1.
3 Move to target position at programmed feed rate.
4 Retract and return to starting point on paraxial path.