HEIDENHAIN MANUALplus 4110 - Manual (Page 447)

HEIDENHAIN MANUALplus 4110 447
8.3 T
ransf
er
Press Program.
Press Program selection.
DIN programs or
DIN macros, or
Cycle programs, or
ICP contours, or
DXF Import.
Press Back.
When DIN programs, or cycle programs, or ICP
contours have been selected, only the file name is
displayed. MANUALplus uses the extensions (see
table at right) to differentiate between the individual
program groups.
If you log on as a "system manager," you can
additionally select the following files:
„ Diagnostic files: These files are important for
commissioning and service.
„ Log files: These files serve to display the stored
error log file (file name: "error") and further files for
commissioning and service.
Program group extensions
NC DIN programs
NCS DIN subprograms (DIN macros)
GTZ Cycle programs
GTI ICP turning contours
GTS ICP face contours
GTM ICP lateral surface contours
DXF DXF contours
Selecting the program group
You can use the same program names for
DIN programs, DIN macros, ICP turning
contours, and ICP contours on face and
lateral surface. It is therefore advisable to
use the "program description" for
explaining the program contents.