HEIDENHAIN MANUALplus 4110 - Manual (Page 360)

360 6 DIN Programming
6.20 F
a
ce Mac
h
ining
6.20 Face Machining
Starting point of contour / rapid traverse G100
Geometry command: G100 defines the starting point of a contour on
the face.
Machining command: The tool moves at rapid traverse along the
shortest path to the end point.
Parameters
 X end point (diameter value)
 C end angle —for angle direction, see graphic support window
 XK end point (Cartesian coordinates)
 YK end point (Cartesian coordinates)
 Z end point
Example: G100
%100.nc
[G100, G101, G102, G103]
N1 T70 G197 S1200 G195 F0.2 M104
N2 M14
N3 G110 C0
N4 G0 X100 Z2
N5 G793 Z2 ZE-5 P2 U0.5 R0 I0.5 F0.15 H0 Q0
N6 G100 XK20 YK5
N7 G101 XK50 B5
N8 G103 XK5 YK50 R50 Q1 B5
N9 G101 XK5 YK20 B5
N10 G102 XK20 YK5 R20 B5
N11 G80
N12 M15
END
Danger of collision!
During G100 the tool moves on a linear path—even if you
program "C" only. To position the workpiece to a defined
angle, use G110.
„ Define the contour starting point or end point either in
polar or Cartesian coordinates.
„ Permitted as machining command only for G100:
Parameter Z